Warranty Information | Installation & Tech
Brake Components Oil Lines Fuel Components Sportswear, ETC.
Brake Rotors Renegade Brake Lines & Fittings Mach 3 Brake Lines & Fittings
Chrome Brake Adapter Fittings Universal Brake Lines Speed Bleeders® & Brake Fluid
Complete Brake & Plumbling App. Guide CycleFlex® Brake Hose Assemblies Brake Line Assemblies
Brake Line Kits & Merchandisers PRO System 1 Bike Builder Series PRO System 2 Bike Builder Series
PRO SYSTEM I COMPRESSION HOSE WITH CLEAR COAT

Engineered for the professional bike builder, Pro System I hose is a 308 stainless steel -3 braided hose specifically designed for high performance brake applications. It features a Teflon® inner liner along with a clear coated exterior for abrasion resistance to painted surfaces. Maximum operating pressure is 2500 PSI. Available with clear coat or smoke tinted clear coat.
 
CLEAR COAT

PART NO. LENGTH SIZE
R3180 10' -3
R3181 15' -3
R3182 20' -3
R3183 50' -3

SMOKE TINT CLEAR COAT

PART NO. LENGTH SIZE
R3480 10' -3
R3481 15' -3
R3482 20' -3

 
HOW TO ASSEMBLE PRO SYSTEM I FITTINGS

1) Wrap tape tightly around hose where cut is to be made.
2) Using either a cut off wheel or fine tooth hack saw, cut hose to desired length.
3) With a sharp knife, trim back the clear coating approx. 1" from end of hose.
4) Disassemble the 3-piece adapter fitting.
5) Slide the tapered nut (taper first) over the hose.
6) Using a small screw driver, separate and open up the stainless braid from the Teflon® inner liner.
7) Slip the brass ferrule (tapered end towards the hose) over the Teflon® inner liner.
8) Lubricate barb with brake fluid and insert the barbed end of the fitting into the Teflon® tube.
9) Draw up the tapered nut and tighten down.


Note: To re-use Compression fittings, you need 5/16" Replacement Ferrule #R20135.
 
© 2007 Edelbrock Corporation