 |
 Adapter Fittings
|
 |
|
Adapter Fittings
|
|
| The last major group of components used in fluid
transfer systems are the Russell Adapter Fittings which are required to adapt the hose
assemblies to whatever you are attempting to plumb. As an example, if you are
plumbing a fuel system you will need fittings to adapt your hose assemblies to the
carburetor, to the fuel pump, a fuel filter, a fuel block (if used), and the fuel
tank. In most cases these components utilize pipe threads and you will use a Russell
fitting which screws into a pipe tapped hole that in turn permits the connection of
the hose end. In other cases, such as the carburetor or the fuel pump, these
components utilize special threads which require a unique adapter fitting to permit a hose
connection. Russell offers a full line of these adapter fittings. Adapter fittings that screw into pipe threads will require some type of thread sealing compound or TeflonÆ tape for sealing. Some other fittings offered by Russell will require an O-ring for sealing or in some cases (such as carb fittings) sealing washers |
 |
Russell offers an extremely wide range of adapter fittings that will provide solutions to just about any plumbing problem you might have. Please refer to the Russell Catalog for the complete line of adapter fittings.
|
If you have any questions or comments about our web
|