| Professional Carburetor Kits: This series is developed for the professional who's requirements demand the maximum in performance and reliability. Each kit is engineered for specific application from race prepared Dominators to dual carb set up's on tunnel ram manifolds. |
 |
A) Russell Balanced Carburetor Kit Part Number 5001 (image currently not available)
This kit includes Russell's Balanced Flow fuel block, Big Bore Carb fittings, Full Flow Hose Ends, and two 8-inch lengths of Pro Flex Hose. All hose and fittings are #6. Two of these kits could be used on dual carb installations using your regulator as your fuel block to feed both Russell Y fuel blocks. It is recommended to use #8 hose to plumb from your regulator to Y blocks and #10 from your fuel cell / tank to the regulator inlet port.
B) Russell Tunnel Ram Kit Part Number #5002 (image currently not available)
This is designed for two single feed Holley carbs
on a dual tunnel ram manifold. These kits include basically the same parts as kit
part number 5001 except the Pro Flex lines are 18-inches long and and the Big Bore Carb
Fittings are for the Holley 600-660 single feed models.
(note: part numbers 5001 and 5002 are sold unassembled allowing for custom fit to
your manifold.)
C) Performance Dual Holley Inlet Kits Part Number 4114, 4115 and 4116
Designed for use with alcohol systems or systems that require a high volume of fuel, these kits feature AN #8 inlet fitting and maintain this large ID throughout. Kits are factory assembled, and incorporate a 1/8" NPT pressure port for gauge / gauge line (fitting included). These kits are available in our Proflex stainless series or where weight is of concern, use Russell light weight Twist-Lok Hose Series.
|
If you have any questions or comments about our web
|